Multimode Media Converter - 10/100 Base-TX to 100 Base-FX - RJ45 to Duplex ST
10/100 Base-TX to 100 Base-FX | 2 Km Range | Convert RJ45 to Multimode ST Fiber Network
Quantity Discount Pricing | ||||
---|---|---|---|---|
1-2 | 3-5 | 6-7 | 8-9 | 10+ |
$87.99 | $86.99 | $85.99 | $84.99 | $82.99 |
Quantity Available: 54
Multimode Media Converter - 10/100 Base-TX to 100 Base-FX - RJ45 to Duplex ST
This media converter is capable of switching between twisted pair and optical transmission for relaying across 10/100 Base-TX and 100 Base-Fx network segments. It achieves high speed interconnection for up to 2 km's relay free. With steady and reliable performance, it is applicable in a wide variety of fields such as, IP data transfers, telecommunications, cable television, railway, finance and securities, customs, aviation, shipping, and is ideal to build broadband campus networks, or intelligent FTTB/FTTH networks. The unmanaged media converter provides an interface between 10/100BASE-TX RJ45 ethernet and 100BASE-FX multimode ST ports. This allows the user to integrate fiber optics into a copper environment.
Features:
- 2 Km Relay Free
- Ethernet standards IEEE802.3, 10/100Base-TX and 100Base-FX
- Multimode ST Optical Port
- RJ45 Port for Twisted Pair
- Auto-Adaptation Rate & Full/Half-Duplex Mode Supported at RJ45 Port
- Auto MDI/MDIX Supported w/o Cable Selection
- 6 LEDs for Status Indication
- External and Built-In DC Power
- 128K Data Buffer
- NIC Transmission Rate: 10/100Mbit/s
- NIC Transmission Mode: 10/100M
- Optical Port Data Rate: 100Mbit/s
Fault Description | Cause Description | Maintenance |
Power LED Lamps are off |
Haven't connected the power cord or it doesn't have a good connection. | Make sure the power cord is connected correctly and make sure there is a good connection. |
Link/Act LED Lamp is off |
1. Haven't Connected the electrical cables to the electrical port or it doesn't have a good connection. | Make sure the power cord is connected correctly and make sure there is a good connection. |
2. Used the wrong electrical cables for electrical connection. | Used the wright electrical cables for electrical connection. | |
3. Any fault with the NIC and the terminal of Ethernet | Make sure the NIC and the Ethernet port are working correctly | |
FX & FX-Link/Act LED Lamps are off |
1. There may be a fault with the optical devices | Check the fiber optical devices and the fiber connection to see of they are working correctly. |
2. The optical fiber has broken down or there is a bad connection. | ||
3. The optical fiber is over-loss | ||
TX and FX LED Lamps are normal but the data can not be transmitted |
1. The Connection between the optical fiber and devices is not valid, this will cause the TX power not to work correctly. | Check the fiber connectors and make sure the connections between optical fibers and devises are valid. |
2. The system only gets power for a moment. If there are any changes in the network it may take a little while for media converters to adapt. | If it still is not working after waiting a few minutes and all connections have been completed correctly, then turn off the power and unplug the power cord, wait for a few minutes and then reconnect the power cord turn device back on and try again. |